In-Stock Orders Ship Same Day (Mon–Fri, Before 12PM CST) | Expedited Shipping Available

Menú
0

In-Stock Orders Ship Same Day (Mon–Fri, Before 12PM CST) | Expedited Shipping Available

0

Tu carrito está vacío

Stud Gun Setup Guide for CD Studs using a Collet Insert

Follow these step-by-step instructions to properly set up your stud gun to weld CD studs.

This setup works for Truweld and StudPro stud welder guns.

Required Parts

1

STEP 1 - Insert Adaptor

Place the Soyer to CI Adaptor inside the gun.  Tighten the shaft nut with a wrench.

2

STEP 2 - Insert Collet Insert

Place the Collet Insert into the Soyer to CI Adaptor.  Tighten the screws in the Soyer to CI Adaptor. 

3

STEP 3 - Make the Foot Assembly

Screw the CD Gun Legs into the foot.

4

STEP 4 - Assemble the stud gun

 Slide the foot piece assembly (CD foot and 2 CD Legs) into holes in the face plate.  Line up the legs so the legs lines up with the face plate.  Adjust so the CD stud sticks out past the foot 1/8" - 3/16" (the plunge).  Tighten the set screws in the face plate.

✓

Setup Complete

Your stud welding gun is now properly configured and ready for use. For additional support or questions, contact our technical team.

Trusted by Industry Pros for Over 60 Years